A tension spring for exhaust elements.Used to connect the different parts of the exhaust system mounted on the engine Top80
Transportation cap to prevent your gas from going out by the event.
4 Motor mount screws.
Cable clamp for gas control
Nut + washer fixing flywheel
Ring, spacer calibration that prevents the spark plug from touch the plunger
Spring of the throttle for Walbro engine Top80.
Plastic protection for the ignition stop button
The valve box gasket is located between the valve box and the motor housing.
The carburetor gasket goes between the carburetor and valve box
Throttle cable 1 mm stainless steel gas control Miniplane
Three springs for the fingers of a hand launcher Top80 engine.
Three short spacers to fix the ventilation turbine.
Screws and washers kit to tighten the Top80 engine coil
M4 screws to attach the launcher on the engine Miniplane Top 80
Fixings engine hood paramotor Miniplane Top80
Base gasket paramotor engine Miniplane Top 80Available in several thicknesses:0.2mm 0.3mm 0.4mm 0.5mm 0.6mm
M5 screw + ring for fixing the propeller hub
Rubber spacer for propeller fastening to Top80 engine
Velcro strap for securing the throttle in the pilot’s hand.
Rope marine type engine starter rotproof for Top 80
Ring For centering the oil reducer on the engine block
Ergonomic handle to start your engine paramotor Miniplane Top80
Plastic gasoline filter, exterior in plastic, interior in cardboard.
Oil for motor reducers TOP 80.
Drain plug and gasket for gear engine Miniplane Top80
Kit of two springs for engine clutch Top 80
Gasket between exhaust and engine cylinder Top 80. Reduces unburned fuel leaks.
Molded spark plug cap screw on the cable coil output paramotor Miniplane Top80
The kit is composed of two springs and two nuts for engine exhaust top 80
Steel plate starter cams and springs support for top80.
Screw cap on top of the gear in oil bath. It incorporates a valve to prevent overpressure in the gearbox.
Wooden Seatplate for paramotor Miniplane std harness
Plastic cap for fuel tank 12 liters on Miniplane Top80 paramotor
Set of three screws securing the ventilation turbine on the Top80 engine
Three manual motor starter pawls for Top80
Pulley returns angle for the passage of accelerator cord to fix on the harness of paraglider and paramotor
Spring shaped tab which facilitates the initiation of a carburetor mounted on the PPG walbro Miniplane Top80
Keychain with mirror system unwinder callback. Pull the mirror, connected by a wire hook and place the front of the tank to control the fuel level. Then release the mirror which come back on the hook remained attached to the harness.
Aluminum mounting flange propeller engine Top 80
Starter spring for Miniplane Top 80 engine
Stainless steel shackle lyre to connect harness to the mobile bars.
Top connection Miniplane bows. Cage 115 or 125.
4 quick clips pack for the paramotor frame Miniplane
Screws, nuts, springs and washers set to secure the flex bars to the frame of Miniplane
Pair of flexible tubes put in the cage for easy sail back inflation.
Kit of two plastic glides to facilitate sliding the chassis
Kit consists of 3 plastic cams, 3 springs and 3 washers for engine Top80 starter.
Plastic pulley that drives the starter’s plastic cams and in which the starter cord is wound
Stainless steel carabiner 6 mm. Connection between a strap (parachute) and a harness